003.02. NURIS

Permanent URI for this community

https://testres.nu.edu.kz/handle/123456789/127

Browse

Browsing 003.02. NURIS by Subject "contact pressure"

Now showing 1 - 1 of 1
  • Thumbnail Image
    ItemOpen Access
    INVESTIGATION OF POWER AND FORCE PARAMETERS OF PRESSING OF PRECISIONS AT THE CONTINUOUS PRESSING MILL OF NEW CONSTRUCTION
    (SERIES OF GEOLOGY AND TECHNICAL SCIENCES, 2020) Mashekov, S. A.; Nugman, E. Z.; Mashekova, A. S.; Bekbosynova, B. A.; Tussupkaliyeva, E. A.; Absadykov, B. N.
    In the article, by using the direct method in the calculus of variations, the mechanism of deformation force development in the matrix, when pressing rods in a new device with is considered, in addition the kinematics of the process is analytically analyzed and the forces acting on the screw-like rolls of this device are calculated. On the basis of the calculated data, it is established that the pressing stress decreases with increasing torques applied to the screw-like rolls of the proposed device. It is proved that with increasing the value of the input angle of the matrix, the forces and the pressing torque are increased. It is shown that the direction of friction forces exerts a significant influence on the pressing stress. The smallest force and the pressing torque are obtained with an angle of friction forces of 45°. The conducted researches made it possible to obtain new scientific data on the force parameters of rod pressing on a new device, and the practical application of the results of the study will ensure an increase in the efficiency of the manufacturing processes of bar products